On site users experiencing slow response from print server. Print jobs have to be restarted. Possible flow control issue? Any Thoughts or Recommendations?
Cisco 4331 Wan Facing "Service Provider" interface
Our Side has a Fiber gbic
GLC-SX-MMD 1000BASE-SX SFP
Interface configuration
interface GigabitEthernet0/0/0
no ip address
media-type sfp
negotiation auto
no cdp enable
sh interfaces gigabitEthernet 0/0/0
GigabitEthernet0/0/0 is up, line protocol is up
Hardware is ISR4331-3x1GE, address is
Description: ->
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 2/255, rxload 5/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive not supported
Full Duplex, 1000Mbps, link type is auto, media type is SX
output flow-control is off, input flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:05:16, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 2977043
Queueing strategy: Class-based queueing
Output queue: 0/40 (size/max)
5 minute input rate 1998000 bits/sec, 374 packets/sec
5 minute output rate 1146000 bits/sec, 382 packets/sec
368523619 packets input, 207278170404 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
3 input errors, 3 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
709847824 packets output, 418252245112 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
6 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
