07-23-2008 01:01 AM - edited 03-06-2019 12:24 AM
error massage:
POST: Inline Power Controller Tests : Begin
POST: Found inline power controller write failure, inst 0
POST: Inline Power Controller Tests : End, Status Failed
Gbic port not functions.
why this happen coz of hardware or software?
07-23-2008 01:15 AM
Too bad; POST-failures are mostly hardware.
Leo
03-20-2009 02:59 PM
Hi,
I've got the same issue. To be more specific I found that i went into this issue only when, in a 3560-24P, i insert both sfp.
If i insert only one of them all is working fine
Had You any news ?
regards
Luigi
03-22-2009 05:57 PM
In enable mode, try the command "show post". The results should be "End, Status Passed". If the result comes back as "failed" then you need to RMA the switch.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide