GUI to configure 4506 with sup2 (ws-x4013)

[Raghavendra Rai]

Hi,

I have a WS-C4506 switch with Supervisor-2 engine (WS-X4013), now i need to configure this switch using GUI.

Can you please suggest a GUI software from Cisco? i tried CNA 5.3 but it does not recognize this switch, CCP also does not recognize this switch.

Thanks,

Raghavendra

[Antonio Knox]

If you are running CatOS, this should get you set up:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a0080094156.shtml

There is a note here, and you will see it quickly on this link:

Note: Catalyst 4500/4000 series switches that run Cisco IOS® system software do not support web interfaces at this time.