Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
712
Views
0
Helpful
1
Replies

GUI to configure 4506 with sup2 (ws-x4013)

Raghavendra Rai
Level 1
Level 1

‎05-24-2011 12:07 AM - edited ‎03-07-2019 12:38 AM

Hi,

I have a WS-C4506 switch with Supervisor-2 engine (WS-X4013), now i need to configure this switch using GUI.

Can you please suggest a GUI software from Cisco? i tried CNA 5.3 but it does not recognize this switch, CCP also does not recognize this switch.

Thanks,

Raghavendra

Labels:
0 Helpful
1 Reply 1

Antonio Knox
Level 7
Level 7

‎05-24-2011 05:35 AM

If you are running CatOS, this should get you set up:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a0080094156.shtml

There is a note here, and you will see it quickly on this link:

Note: Catalyst 4500/4000 series switches that run Cisco IOS® system software do not support web interfaces at this time.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card