The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Packet loss and/or high latency are usually indicative of congestion. You might add bandwidth (to avoid the congestion) and/or you might manage the bandwidth (QoS).
As to your switch having low CPU and memory utilization, if traffic is being processed by dedicated hardware (e.g. ASICs) then that's expected.
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...
Whether you're attending VMworld 2019 on-site or from afar, read the latest on the key themes to expect. They are also the key themes for IT management today, from software defined everything to cloud and automation to IoT and edgecomputing : http:...