How can I config Port-channel from ASA to Core Switch and assign IP?

[NetworkRookie]

I've got 2 ASA and 2 Core Switch stacked. How can I config Port-channel from ASA to Core Switch and assign IP to Port-Channel of ASA, Coreswitch. Look like gateway will be .1 in core and .2 in ASA. 
From ASA1, I already used 4 ports from g1/1 - g1/4 for port-channel and g1/1-2 from ASA2 
here my config: 
Core: 

Vlan 101 

vlan 102

int range g1/0/45-48 

channel-group 1 mode on 

int po1 

sw trunk encaps dot1q 

sw trunk native vlan 101 

sw mode trunk 

int range g1/0/43-44 

channel-group 2 mode on 

int po2 

sw trunk encaps dot1q 

sw trunk native vlan 102 

sw mode trunk 

ASA1: 

int g1/1

no sh 

channel-group 1 mode on 

int g1/2 

no sh 

channel-group 1 mode on 

int g1/3 

no sh 

channel-group 1 mode on 

int g1/4 

no sh 

channel-group 1 mode on 

int po1.101 

vlan 101 

ip add 10.1.0.2 255.255.255.248 

no sh 

nameif Inside 

security-level 100 

ASA2: 

int g1/1

no sh 

channel-group 2 mode on 

int g1/2 

no sh 

channel-group 2 mode on 

int po2.102 

vlan 102 

ip add 10.2.0.2 255.255.255.248 

security-level 50 

nameif Internal 

and here are subnets for 2 vlan: vlan 101: 10.1.0.0/29 vlan 102: 10.2.0.0/29 

[marce1000]

 >... How can I config Port-channel from ASA to Core Switch and assign IP to Port-Channel 

          You can't assign an IP address  to a layer2 interface , only to Vlan(SVI)

 M.

[NetworkRookie]

Light me.  
As you said. I can assign IP to int vlan 101 and vlan 102 in CoreSW, so how can I switch int po1 and int po2 access to vlan 101 and 102? 
I've read about Cisco ASA 5506 and higher removed vlan, so I can Switch port access to vlan in ASA5506 

[balaji.bandi]

as per your question, you need to do as below on the Core switch :

 interface Vlan 101 

ip add 10.1.0.1 255.255.255.248 

no shutdown

interface vlan 102

ip add 10.2.0.1 255.255.255.248 

no shutdown

is this cluster deployment, then you need cluster link also.

https://www.cisco.com/c/en/us/td/docs/security/asa/asa96/configuration/general/asa-96-general-config/ha-cluster.html

[NetworkRookie]

it's stand alone deployment, not clustering or something like that. 
It's a simple network topo ASA1 > Core > ASA2. Stand alone. 

[balaji.bandi]

That above suggested config should work for you.

[NetworkRookie]

I've tried your suggest config but it's not work. maybe I did something wrong. 

[MHM Cisco World]

it depend on 
if you want you can config VLAN SVI in ASA 
or config sub-interface ins ASA