How do you ground a 2960x switch?

[patrick.lally1]

I don't see any screw holes for grounding lugs. There are holes for screws on all the other products I've used from Cisco. Any ideas?

[Jason Dodge]

Same.... there's a clear spot on 3560x, nothing on 2960xr? I'm putting a couple PoE with full power redundant power suppies into a DC plant and required to bond. Not really sure if those designtated spots afford any more protection or are any different from any other part on the device's chasis though....?

[Ganesh Hariharan]

Hello Patrick,

Are you saying only raw switch been shipped without any screws and mounting kits ??

If that is the case , The either purchase or connect with cisco team with whom purchased was done.

Have a look on the below link for installation and mounting 2960 in various ways.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/hardware/installation/guide/2960_hg/higinstl.html

Hope it Helps..

-GI

[eric.mackay@iapws.com]

So , there's no external attachment point like the rest of your equipment

Reading through your manual it even describes it but I guess this is  just generic copies sent with all equipment ? 

[eric.mackay@iapws.com]

Did you every fine your answer ??

[miguel.carrillo]

Anyone have an answer for this question?