Hi Guys,
I have an issue with couple of Cisco 4900M switches. We just got them and tried to use the
TwinGig Converter on the 4 ports 10G module.
The problem is that the switches sees the new module in slot 2 and when we are inserting the TwinGig Converters we are getting the error message and when we are trying to type the command this command it does not work.
"hw-module module <slot> port-group <group> select gigabitethernet"
When we go to config T, the only thing we can type is
"hw-module module <slot> and if we do a ? the only thing is available is logging and power and we can't type
Port-Group or anything else. Does anybody know why? is this a hiden command or we have to something else?
Thanks
Sia