How to configure BPDU Skew detection logging in Switch

[shanilkumar2003]

Hi

Anybody can help to configure BPDU Skew detection in Switches in detail

Thanks in Advance,

Shanil

[mfurnival · Accepted solution]

This document explains how to configure it

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a0080094640.shtml

Though it does point out that this is not supported in IOS - only CATOS.

[InayathUlla Sharieff · Accepted solution]

Shanikumar,

As said this is currently supported on Catos, if your devices are running Native IOS then this cannot be achieved as of now.

Please go through the above link and update us back if you required any further help you required.

Regards

Inayath

[shanilkumar2003]

Thanks all for the clarification. but wondering why cisco is not implementing it in IOS,as it would be helpful to proactively monitor for any STP issues

Regards,

Shanil