Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Is it possible to have an interface that is both a destination in a local SPAN session and a destination in an ERSPAN session?
So for example I have Switch A and B. On Switch A G0/1 is destination in a local monitor session and is also a destina...
I want to set up a monitor session on an interface that is connected to a IP phone (not a Cisco one). I am just curious to understand how it works with the monitor session with regard to the VLAN tagged traffic on that port. So the phone will have a ...
Can't find the answer I am looking for anywhere...What is the preferred order of operation when adding additional VLANs to a Port-Channel already in trunking mode?Do I add it to the physical port first then the port channel? Or the other way round?
We have two sites connection via an IPSEC tunnel and periodically we see the EIGRP adjacency between the two sites will go down:Mar 2 03:58:52.495: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 200: Neighbor 10.1.1.1 (Tunnel1) is down: holding time expired.Mar 2 ...
Yeah I read that statement too and was not sure how to interpret it. I am asking if a port can be a destination port in a SPAN session and an ERSPAN session, not two SPAN sessions.
Unfortunately I don't have any kit at my disposal to test this out o...
The 8 port switch would not be used for WAN termination. Have a look here at the other ISR routers:
https://apps.cisco.com/ccw/cpc/concept/268437899
It is a bit hard to make solid recommendations without knowing what other requirements need satisfyin...
That is a very broad request - pretty much any Cisco router will have WAN interfaces that you can put an IP address on. Can you be more specific? Are there any more requirements that need satisfying such as interface termination, throughput etc?
Hi,
You need to configure "Enhanced Object Tracking" (this link refers to 3750 switches but gives a good overview: http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/12-2_55_se/configuration/guide/3750xscg/sweot.h...
