12-16-2009 07:29 PM - edited 03-06-2019 08:59 AM
Hi,
How to configure the SNMP traps for Cisco SAN Switch?
I would like to configure multiple SNMP traps in order to communicate to our Storage Network Management system and associated Community string (Private network).
Best Regards,
ChinSeong
12-16-2009 08:57 PM
12-17-2009 01:58 AM
Hi,
Check out the below link hoe this helps
http://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a0080662d15.html
Regards
Ganesh.H
12-17-2009 07:27 PM
Hi,
Thanks for the replies. I'm not sure whether I did it correctly or not.. I've configured as below:
The text that highlighted in blue is the newly add snmp traps... and how do I verify whether it is work? Any way to test it out?
Again... Thanks for the advise..
Network management server's IP: 168.50.31.100
Unique SNMP trap: I77V5eRAUEAa
UDP Port: 162
Telnet to the switch....
CiSCO_MDS_SW1# conf terminal
Enter configuration commands, one per line. End with CNTL/Z.
CiSCO_MDS_SW1(config)# snmp-server host 168.50.31.100 traps version 2 I77V5eRAUEAa udp-port 162
CiSCO_MDS_SW1(config)# exit
CiSCO_MDS_SW1# show snmp host
Host Port Version Level Type SecName
____ ____ _______ ______ ____ ______
169.168.151.123 2162 v2c noauth trap public
168.50.31.100 162 v2c noauth trap I77V5eRAUEAa
CiSCO_MDS_SW1# copy run start
[########################################] 100%
CiSCO_MDS_SW1#
Thanks.
12-17-2009 11:09 PM
Hi,
Check out at snmp server that it is able to discover the SAN switch after proper configuration in SAN Switch.
This way you can check that SAN switch is discover via snmp.
Hope this helps !!
Regards
Ganesh.H
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide