How to copy configuration from USB to Cisco 9300 Flash?

[Zac88]

Hi,

I would like to know how to copy configuration from USB to Cisco 9300 flash?

Is there any guide for this?

Thank you.

[Leo Laohoo]

Command: copy usbflash0:<FILENAME> run

or

Command:  copy usbflash0:<FILENAME> start

[brselzer]

One last option would be copy usbflash0:<FILENAME> flash: if you just want to save it to the switch without loading it into the startup or running config. 

[Zac88]

How about the config file? Is it same like 3750? just copy config.text?

[Leo Laohoo]

Same thing.

[rgiorgi01]

Hi Leo,

 When I try to do it it says: Unsupported destination device/filesystem

 and I think is because flash: is ro and not rw

                   supported filesystem(s):
                   flash: ro flash
                   bootflash: ro system partition
                   usbflash0: rw front-panel USB
                   usbflash1: rw back-panel USB

[Leo Laohoo]

Not all USB flash drives are supported by Cisco kit.  

Maximum size is 16 Gb and needs to be formatted to FAT16.