Hi, i am new to cisco Nexus devices, I am trying to configure default-route:I want to my server (192.168.10.5, vlan 500) can access to default gateway (192.168.1.1) at pfsense.My switch is Cisco N3K-3064PQe1/1 connected to pfsense as routed porte1/5 ...
I would like to redirect the HTTP & HTTPS traffic from only one of the VLAN/segments in my network to the proxy server that listening to port 8080. This is for me to have control from the network level instead of doing a proxy configuration on the e...
Hello, I was upgrading the firmware of one of our 2960-X Switches to c2960x-universalk9-tar.152-2.E3. When the firmware was updated the switch rebooted and was coming up with "BOOT FAIL". I am not able to get to ROMmon. It has no reaction if I press ...
Hi everyone, I am upgrading a pair of 4500X in VSS from 3.08 to 3.11, rommon version is "15.0(1r)SG12" I did not see anything in the release notes, that would stop me from doing the upgrade, I am planning to do the following steps. ActionCommandBacku...
We have 2 server rooms in different buildings 200 meters apart. Is VSS still the only VPC alternative for IOS switches. We would have to run atleast 32 fiber pairs between buildings. Also does it create a limitation if the 6800 switches are already i...
configuration terminal ip access-list extended BUFFER-FILTER permit ip any any exit exit monitor capture buffer BUFFER size 20000 circular monitor capture buffer BUFFER filter access-list BUFFER-FILTER monitor capture point ip process-switch...
Hi!I want to block UDP (best of all) traffic from vlan220 to vlan100, and allow udp traffic from vlan100 to vlan220.Is there something new in the new IOS-XE? TCP works fine. But unfortunately, certain services using UDP are unavailable.Thanks! PGI
Hello,i have 2-4gbps bps and during attacks 4-5m pps and i want to lunch 10-12x GRE tunnel and total trafic for gre tunels are around 500-600mbps and i have 3x 10G uplink from different ip transtis and i have full bpg table from them so i have 2 opti...
Hi, is it possible to upgrade C9200 switch base license from Network Essentials to Network Advantage? Or is the license permanently tied to each SKU without the posibility of an upgrade? If the upgrade is possible, does it apply for both C9200 and C9...
I had everything setup but I think I messed up up the ACL, It wont ping anymore. Im suppossed to Complete routing using OSPF and all PC's should be able to ping each other but not the server. The server should be reachable to open the web page. My pa...
Hello, I am using Cisco packet tracer of version 8.0 in Windows 10. When I tried to access the GUI of Router to configure. It was missing. Then I checked the preferences section. But "Hide GUI " option was unchecked there too. Then I tried...
Hi,we are managing multiple office which ask for Public IPs (if required by them). we have pool of multiple public IP addresses and we give them the IP from the pool to use them on their router on their end. we have 2 vlans setup on our layer 3 switc...
Hi I wonder if IE2000 will get support for DLR (Device Level Ring) ?
on the MLS switch it doesn't transfer the packet to the other MLS switches over the routers
Hi We have a Catalyst 3850-24T-E. We are trying to configure and use vrf-aware DNS. We have done the following: ip domain-lookupip name-server vrf my_vrf 192.168.1.100show host vrf my_vrfName lookup view: my_vrfDefault domain is not setName/address...
