06-14-2019 08:46 AM
I have Interface 25 on a Cisco SW350 Switch configured as follows:
fhg#show run interface gigabitethernet25
interface GigabitEthernet25
description FHG-KIN-FW01-FE2
port security max 10
no spanning-tree portfast
switchport access vlan 119
switchport trunk allowed vlan 1,119
no macro auto smartport
!next command is internal.
macro auto smartport dynamic_type unknown
!
How to i disable the Macro on this Interface Port 25 ?
06-14-2019 09:37 AM
- You may try defaulting the interface (default int x/y) and (only) apply the needed configuration commands again.
M.
06-14-2019 09:44 AM
Dear Marce,
I already tried Defaulting it by typing the following commands on the CISCO SG350-28P Switch by typing the following commands:
config t
default interface gigabitethernet25
But it gives an error "Unrecognized command".
06-14-2019 09:49 AM
Dear Marce,
I already tried Defaulting it by typing the following commands on the CISCO SG350-28P Switch by typing the following commands:
config t
default interface gigabitethernet25
But it gives an error "Unrecognized command".
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: