cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
145
Views
0
Helpful
3
Replies

How to disable macro from the Configuration of a Switch

I have Interface 25 on a Cisco SW350 Switch configured as follows:

fhg#show run interface gigabitethernet25
interface GigabitEthernet25
description FHG-KIN-FW01-FE2
port security max 10
no spanning-tree portfast
switchport access vlan 119
switchport trunk allowed vlan 1,119
no macro auto smartport
!next command is internal.
macro auto smartport dynamic_type unknown
!

 

How to i disable the Macro on this Interface Port 25 ?

 

3 REPLIES 3
Highlighted
Rising star

Re: How to disable macro from the Configuration of a Switch

 

 - You may try defaulting the interface (default int x/y) and (only) apply the needed configuration commands again.

 M.

Re: How to disable macro from the Configuration of a Switch

Dear Marce,

 

I already tried Defaulting it by typing the following commands on the CISCO SG350-28P Switch by typing the following commands:

 

config t

default interface gigabitethernet25

 

But it gives an error "Unrecognized command". 

 

Everyone's tags (1)

Re: How to disable macro from the Configuration of a Switch

Dear Marce,

 

I already tried Defaulting it by typing the following commands on the CISCO SG350-28P Switch by typing the following commands:

 

config t

default interface gigabitethernet25

 

But it gives an error "Unrecognized command". 

Everyone's tags (1)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards