How to make a port on the router static

[Roshan8484]

Hello,

My current Cisco Router 1812 configs. are as:

1. My DSL connects to the FE0 port.

2. My ports FE2-FE9 are automatically assigned IP addresses via the DHCP server from VLAN 1.

What I want to do is stay on the same vlan but assign my printer which is hooked up to my FE2 port a static IP how do I go about doing this.

[Jerry Ye]

Hi,

I am assuming you are using IOS version 12.4. Here is how you can create DHCP manual binding:

http://www.cisco.com/en/US/docs/ios/ipaddr/configuration/guide/iad_dhcp_svr_cfg_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1155880

Please see the following link for configuration example:

http://www.cisco.com/en/US/docs/ios/ipaddr/configuration/guide/iad_dhcp_svr_cfg_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1099484

HTH,

jerry

[Roshan8484]

I dont know i set everything up via SDM so it was easy to configure.

[Jerry Ye]

Hi,

Under SDM -> DHCP, you should see "DHCP Bindings". You can configure MAC address and IP address mapping manually.

Make sure the "Identifier" is Hardware address

and "Type" is IEEE 802.

HTH,

jerry