Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

Howdy all, I'm looking at upgrading the IOS on this switch to a later release. I guess I should back up and mention that I'm using a Sup IV engine so it's not running CATOS. When I go to download the latest version I need to select the correct feat...

Howdy all! I've been noticing this error on my 4006 allot since I upgraded the Supervisor Engine from a Sup II to a Sup IV. The port that's cause error's has my firewall attached to it (ASA 5510). Any thoughts?*Aug 12 20:10:53: %C4K_L2MAN-6-INVALI...

I have a Cisco 871 Ethernect access Router. While configuring the Router, it became inoperative. I would like to know if there is a procedure to reset the Router to its default configuration? If so where could I get the procedure?

dbdickson by Level 1
  • 650 Views
  • 3 replies
  • 0 Helpful votes

Resolved! IOS Documentation

Could someone give me direction as to where i can retrive documentation defining the different versions of IOS. For example, the difference between YA & XZ. I can find what feature a particular IOS has, but was looking for the differences between t...

dphills18 by Level 1
  • 997 Views
  • 3 replies
  • 0 Helpful votes

Hi,We are having two access switches(4507) which in turn is connected to two core switches(4510).Recently, we tried to add two vlans in the access switches (one for data & one for voice) & configured hsrp.All of a sudden the network went down.I have ...

HI in our LAN we find a weird issue. Our ip range is 172.20.48.0 /20, when to try to ping any ip address from the pc it resolves to ips in the network range 172.20.62.x or 63.x and the MAC address for those IPs seems to be same, i have attached the s...

Do i need a vlan configured on a switch in ordre for traffic on that vlan to traverse the switch on a trunk.So, i have trunks between switch 1 and 2. and i have a trunk between switch 1 and 3. I have access ports in vlan 100 on both siwtch 2 and 3. D...

How do you transfer a bootable IOS to a switch from the bootloader switch: prompt? Documentation refers to copy command, but parameters only support flash file system reference. I had a corrupt image in flash, and was forced to delete it, and now t...

jvoilea07 by Level 1
  • 927 Views
  • 3 replies
  • 0 Helpful votes

Hi,We currently have a single 6509 with the following configuration.Mod Ports Card Type Model --- ----- -------------------------------------- ------------------ 1 2 Catalyst 6000 supervisor 2 (Active) ...

hi, I would like to know how do the Cisco network devices as well as FWSM communicate with different VLANs defined on Cat6500 24/48 port switch. Is SVI required for every VLAN defined on Cat6500 switch ? For e.g. if an ASA is connected to VLAN2 (192....