11-27-2013 11:42 PM - edited 03-07-2019 04:49 PM
Dears,
We just bought a new module WS-X6816-10GE, and insert into Cat6509 slot 8 by test.
And now we move it back to slot 7, then show module, the new module appears on both slot 7 and 8.
Then I try to reload module, and show module again, It's come back to normal.
Mod Ports Card Type Model
--- ----- -------------------------------------- ------------------
1 24 CEF720 24 port 1000mb SFP WS-X6824-SFP
3 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6848-GE-TX
5 5 Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G
7 16 CEF720 16 port 10GE WS-X6816-10GE
But through show run commond, I still see the interface TenGigabitEthernet8/1 -16 in it.
And I tried to use "no interface te8/1" to remove the interface from running-config, but it doesn't work.
Is there any way for me to remove it from running-config without reboot switch?
Solved! Go to Solution.
11-28-2013 04:42 AM
What you should have done is use the module clear-config command before removing the module. What you can try is to put the module back into slot 8 and then follow the instructions in this link -
Jon
11-28-2013 12:27 AM
hi
hehe,First encounter,It does not affect your work on slot 7 .
11-28-2013 12:35 AM
Hi, Weijun
That config is stored in RAM, and everyting works fine.
If I backup it to tftp, and modify the config then copy it back to run, the running-config will be "merged" but not overwrited.
I afraid that I need to reboot the switch
11-28-2013 04:42 AM
What you should have done is use the module clear-config command before removing the module. What you can try is to put the module back into slot 8 and then follow the instructions in this link -
Jon
12-01-2013 08:23 PM
Dear Jon.marshall,
OK, got it,
I'll try it, Thanks a lot.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide