10-23-2015 09:05 AM - edited 03-08-2019 02:21 AM
hi,
some operation shows you a lot of information appears on the console.
what command should I use to send debug to TFTP server (and should not appear on console) ?
10-23-2015 09:50 AM
set debug but not to the console , do not have logging console or monitor terminal set
Then use this to redirect your full logs which will contain the debugs
set your logging buffer to high value if debugging or it will overwrite
sh logg | redirect tftp:xxxxxx
10-23-2015 01:56 PM
I tried but it shows me:
R24#show logg | redirect tftp://192.168.1.105/logg.txt
.....
%Error opening tftp://192.168.1.105/show.ip.route.txt (Timed out)
there is no issue in the connectivity with tftp server.
10-23-2015 11:49 PM
I tried but it shows me: R24#show logg | redirect tftp://192.168.1.105/logg.txt ..... %Error opening tftp://192.168.1.105/show.ip.route.txt (Timed out) there is no issue in the connectivity with tftp server.
Hi Mohammed,
You can directly send traps to syslog daemon by using below commands.
logging host <ip address of PC> --> defines that location of your syslog server
logging trap 7 --> 7 is the interchangeable with "Debug"
logging on -- > Making Logging On
Hope it Helps..
-GI
Rate if it Helps..
10-27-2015 02:17 AM
make sure your firewall is off locally on any device in path
10-23-2015 12:34 PM
may use syslog
no logging console
logging <to Syslogserver>
logging monitor debugging
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide