09-04-2019 07:20 PM
How to set static arp entry on interface on cisco Routers?
09-04-2019 11:52 PM
https://community.cisco.com/t5/networking-documents/how-to-configure-static-arp/ta-p/3132658
M.
09-05-2019 12:05 AM
Hello Marce,
thanks for your reply but i want static Arp entry on interface and when i'm trying to define port like "arp ip-address hardware-address type arpa interface gi0/1" then getting error like bad address only for bridge ip something like this.
Pleae let me know how to set on interface?
thanks
Amit Kumar Sharma
09-05-2019 12:43 AM
Hello,
I think you can only use the full command specifying the interface when the interface is in Layer 2 mode. With a layer 3 interface, you can only use the IP address followed by the MAC address and the 'arpa' keyword, e.g:
arp 1.1.1.1 0202.0101.0909 arpa
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide