06-08-2016 11:05 AM - edited 03-08-2019 06:07 AM
Is there a command similar to "test etherchannel load-balance int port-channel # ip 1.1.1.1 2.2.2.2" (available on the 3750 switches) for 3850 switches. I cannot find a way to test which interface of a port channel a particular flow will use.
06-08-2016 11:50 AM
did you try this command
show etherchannel (number) port-channel
06-08-2016 12:12 PM
Yes, but "show etherchannel # port-channel" does not allow you to specify a particular source and destination IP to determine which one of the individual interfaces of the port channel the traffic from the specified source IP to the specified destination IP will use.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: