Switching

Hi all, Can I configure wccp with Nexus 9372? Thanks.! 612

At the weekend I had an engineer take a look at our (basic) switch configuration with regards to an issue we were having when using failover on our firewalls. We had recently installed new switches and used the configuration of the existing switches ...

Hi all, I have a question, is possible configure on router 2921 with a switch module (ehwic-d-8esg) flex-link to two end host?, My intention is have two server with the same configuration Ip address, DB etc and when the server primary this inactive,...

Hi All,   I have a couple of Linksys SRW switches, that I need to login to verify some configurations. I tried two different Female to Female adapter cables and does not work. I do not think I have the proper console cable for them. Can someone guide...

Hello, I'm looking for thoughts, opinions, and experiences with opting to go with Nexus in the LAN core vs. a Catalyst 4500/6500/6800. Not concerned about FWSM/WISM modules or PoE - purely L3 routing, multicast rp, etc. Thanks, Chris

Obligatory "I am new to configuring Cisco switches" comment and I apologise if I am asking a silly question. The issue in a nutshell is that when configuring a stack of two Catalyst 3850 switches, if I convert a trunk port with one VLAN allowed to a...

Hi Team, We can able to do telnet, but not able to do ssh, we checked its not configured. We tried to configure, but didn't get any ssh command in the switch. My device details. cisco WS-C3560G-24TS -Version 12.2(25r)SEE4 line vty 0 4 login authentic...

Mar 9 18:54:49.259: %NGWC_PLATFORM_FEP-6-FRU_PS_OIR: Switch 2: FRU power supply B inserted*Mar 9 18:54:49.370: %PLATFORM_STACKPOWER-6-CABLE_EVENT: Switch 2 stack power cable 2 inserted*Mar 9 18:54:49.370: %PLATFORM_STACKPOWER-6-LINK_EVENT: Switch 2 s...

Nexus 3064 with N3K-BAS1K9 support RIPV1 , RIPV2 , NSSA (OSPF) , OSPFV2. ?

Hi there.I could install my very first 4500-X VSS stack (2 members) and I connected the Fa1 of both switches to the network. On that Fa1 I do have the management IP. It's configured like this:interface FastEthernet1 description management vrf forward...

Nexus 3064-X support 802.3ac and native vlan or not ?

Hello,  I have an SG200 26 port switch and 2 basic Cisco routers.   From my ISP I am going into router A.  From Router A I am connected to another cisco router B as an Access point and connected to the switch.  10 Computers and Backup are wired to Sw...