HSRP & bridge-group problem

[venancio.martinez]

When I associate a interface vlan of a Cat6509 to a bridge-group, local switch cannot see through hsrp the partnet switch. Bridge-group is neccessary because we need dlsw+.

[John Blakley]

Can you post the relevant parts of the config?

HTH,

John

[venancio.martinez]

Here you have the config:

dlsw remote-peer 0 tcp 10.33.1.4

dlsw icannotreach sap AA E0 F0

dlsw bridge-group 1

dlsw udp-disable

int vlan 28

bridge-group 1

bridge 1 protocol vlan-bridge

bridge 1 priority 20000

RSDCPD1#sh standby vlan 28

Vlan28 - Group 28

Local state is Active, priority 100, may preempt

Hellotime 1 sec, holdtime 3 sec

Next hello sent in 0.899

Virtual IP address is 180.165.28.1 configured

Active router is local

Standby router is unknown

Virtual mac address is 0000.0c07.ac1c