HSRP configuration

[battanc]

Does anyone know if a HSRP configuration is possible between three switches?
These are two 4506 and a 3850.
It is currently in operation between the two 4506, but I should add the 3850
Thank you

Claudio

[Spooster IT Services]

Hi Battanc,

Yes, you can configure HSRP on three switches.

One will be active, second will be standby and third will be in listen state.

http://www.ciscozine.com/implementing-high-availability-with-hsrp/

https://supportforums.cisco.com/discussion/10802261/hsrp-3-switches

If this was helpful, please give it a thumbs up

[Julio E. Moisa]

Hi Claudio,

Yes you can, if you use the same HSRP group you will have:

Active device
Standby device
and the 3rd device will have the Listen state, it should have a priority lowest than active and standby priorities. 

I have seen until 4 HSRP devices on the same HSRP Group.

Hope it is useful

:-)