HSRP Problems

[ricardo-morales]

i have two 4507R working in HSRP, also i has varios cluster, one of then has exchange for mail service, they works with cluster microsoft,(various aplicacion each one with a ip, but i get all service by one IP) the problems occurs whe they make a failover i have to include an static arp ARPA in on of the two 4507r to get works well when they make a failover again i have to erase the static arp and include it in the other 4507 or make a trace to know where i get the cluster.

[yvk.kishore]

hi recardo..... can u just send me the configs of the vlan that u are using in both 4507R switches....so that i can analize more on this...

[ricardo-morales]

i am sending a sh vlan.

[jackyoung]

If you enabled the multicast in the network, it may capture the HSRP hello packet. Check below link for reference :

http://www.cisco.com/en/US/products/hw/switches/ps679/products_configuration_guide_chapter09186a008007f7ea.html

But the command may not be supported by 4507R.

Try to check below link for the troubleshoot and apply corresponding ACL to the interface. Please check case study 7 and whole article. Or try the BIA command to allocate the MAC address.

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml

Sorry for not tried this and not able to tell the exact solution. Please advise the result when you tested the solutions.

Hope this helps.

[ricardo-morales]

4507R Does not support that.

thanks

[jackyoung]

How about the BIA, can it support ?