I have 2 IE-4010-4S24P on my bench that when I run a diagnostic start test all I get a failure on TestPortAsicLoopback, after a reload the failure still exists. Does anyone know what could cause this, or is this likely a hardware issue?
2) TestPortAsicLoopback ------------> F
Error code ------------------> 1 (DIAG_FAILURE)
Total run count -------------> 2
Last test testing type ------> OnDemand
Last test execution time ----> Mar 29 2011 20:51:14
First test failure time -----> Mar 29 2011 21:06:43
Last test failure time ------> Mar 29 2011 20:51:14
Last test pass time ---------> n/a
Total failure count ---------> 2
Consecutive failure count ---> 2
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 28 IE-4010-4S24P 15.2(8)E2 IE4010-UNIVERSALK9-M
