12-23-2019 08:06 AM
Hello everyone,
I have encounter the following issue.
Two switches connected via trunk on the same native vlan.
Switch A after running cdp neighbour detail:
SW-GF-08#sh cdp neighbors detail
-------------------------
Device ID: SW-PTC-01
Entry address(es):
Platform: cisco WS-C3850-48P, Capabilities: Switch IGMP
Interface: FastEthernet0/8, Port ID (outgoing port): GigabitEthernet1/0/46
Holdtime : 136 sec
Version :
Cisco IOS Software [Everest], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 16.6.6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2019 by Cisco Systems, Inc.
Compiled Thu 11-Apr-19 02:24 by mcpre
advertisement version: 2
VTP Management Domain: ''
Native VLAN: 998
Duplex: full
-------------------------
port config switch a
interface FastEthernet0/8
switchport trunk native vlan 998
switchport mode trunk
switchport nonegotiate
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust dscp
spanning-tree guard root
port config switch b
interface g1/0/46
switchport trunk native vlan 998
switchport mode trunk
service-policy output PER-PORT-QUEUING
switchport nonegotiate
spanning-tree guard root
Any advice would be highly appreciated.
Thank you.
Solved! Go to Solution.
12-24-2019 04:25 AM
After connecting the client the management vlan status changed to up/up and the IP address is visible in the cdp neighbours detail. No configuration changed was completed.
12-23-2019 08:32 AM
Hi,
You need to have an SVI on each switch to be able to see the IP
interface vlan 998
ip address x.x.x.x
HTH
12-23-2019 08:46 AM
Hello,
in addition to Reza's post, (obviously) make sure that Vlan 998 exists on both switches. When you do a 'sh ip int brief' the status of Vlan998 should be up/up on both switches...
If the Vlan does not exist, you need to create it:
SW-GF-08#conf t
SW-GF-08(config)#vlan 998
SW-GF-08(config-vlan)#end
SW-PTC-01#conf t
SW-PTC-01(config)#vlan 998
SW-PTC-01(config-vlan)#end
12-24-2019 04:25 AM
After connecting the client the management vlan status changed to up/up and the IP address is visible in the cdp neighbours detail. No configuration changed was completed.
12-24-2019 05:54 AM
Hello,
the management VLAN needs to be up/up indeed (just like any iinterface actually) for the IP address to become active...glad that you got it resolved.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide