03-20-2019 03:48 AM
Hello,
we have a switch stack (2x WS-C2960S-48LPS-L and 2x WS-C2960X-48FPD-L) whith global feature "ip device tracking" activated.
However, the "show ip device tracking all" command displays only interfaces from the first switch, although it indicates that the feature is enabled on all interfaces.
Switch#sh ip device tracking all
Global IP Device Tracking for clients = Enabled
Global IP Device Tracking Probe Count = 3
Global IP Device Tracking Probe Interval = 30
Global IP Device Tracking Probe Delay Interval = 0
IP Device Tracking Probe Auto Source = Enabled
Probe source IP selection order: SVI,Fallback 0.0.0.30 255.255.255.0
-----------------------------------------------------------------------------------------------
IP Address MAC Address Vlan Interface Probe-Timeout State Source
-----------------------------------------------------------------------------------------------
XX.XX.XX.XX abcd.1234.abcd 100 GigabitEthernet1/0/1 30 ACTIVE ARP
XX.XX.XX.XX abcd.1234.abcd 100 GigabitEthernet1/0/2 30 ACTIVE ARP
XX.XX.XX.XX abcd.1234.abcd 100 GigabitEthernet1/0/3 30 INACTIVE ARP
XX.XX.XX.XX abcd.1234.abcd 200 GigabitEthernet1/0/4 30 INACTIVE ARP
Total number interfaces enabled: XXX
Enabled interfaces:
Gi1/0/1-48, Gi2/0/1-48, Gi3/0/1-48, Gi4/0/1-48
I've already tried to enable "IPDT" at the interface level. Unfortunately without success. If I display "IPDT" for each interface of the stack, it indicates that "IPDT" is disabled. It does not matter which switch the stack is.
Switch#sh ip device tracking interface Gi 1/0/1
--------------------------------------------
Interface GigabitEthernet1/0/1 is: STAND ALONE
IP Device Tracking = Disabled
IP Device Tracking Probe Count = 3
IP Device Tracking Probe Interval = 30
IPv6 Device Tracking Client Registered Handle: 125
IP Device Tracking Enabled Features:
HOST_TRACK_CLIENT_SM
--------------------------------------------
Does anyone know the command with which "IPDT" can be activated on all interfaces of the stack?
Thanks & Best regards
03-20-2019 04:32 AM
Hello
@Martin Moedinger wrote:
Switch#sh ip device tracking interface Gi 1/0/1
--------------------------------------------
Interface GigabitEthernet1/0/1 is: STAND ALONE
IP Device Tracking = Disabled
IP Device Tracking Probe Count = 3
IP Device Tracking Probe Interval = 30
IPv6 Device Tracking Client Registered Handle: 125
IP Device Tracking Enabled Features:
HOST_TRACK_CLIENT_SM
--------------------------------------------
Does anyone know the command with which "IPDT" can be activated on all interfaces of the stack?
Is the above interface active?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide