Solved: Paul.

Computerwiz24 · ‎07-09-2016

Hello,

I have a cable modem connected to a cisco 1841 router which i want to do NAT on. I cant get the NAT overload to work. In the show ip nat translations it appears my outside global and outside local IP addresses are incorrect. Has anybody seen this before? My running config is attached. Thank you

paul driver · ‎07-10-2016

hello

your nat config looks okay so try changing your default route

no 0.0.0.0 0.0.0.0 xxx.xx.xxx (ISP Default Gateway)

ip route 0.0.0.0 0.0.0.0 dhcp

res

paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

paul driver · ‎07-10-2016

hello

your nat config looks okay so try changing your default route

no 0.0.0.0 0.0.0.0 xxx.xx.xxx (ISP Default Gateway)

ip route 0.0.0.0 0.0.0.0 dhcp

res

paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Computerwiz24 · ‎07-10-2016

Paul.

I changed the default route and also found an amateur mistake on my DNS address i set on the nic of the pc. It is working great now. Thank you for the help!

Adam

IP NAT not working