cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
13033
Views
0
Helpful
4
Replies
Highlighted
Beginner

IP on VLAN or IP on Loopback in VLAN

On a current Catalyst product Is it better to assign an IP address directly to a VLAN interface or to assign an IP address to a Loopback interface that is in a particular VLAN?  What are the benefits or pitfalls of either method?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

IP on VLAN or IP on Loopback in VLAN

Hi ,

You cannot configure the loopback interface as switchport. Also you cannot configure a SVI ( interface vlan ) as a switchport. So the solution is to configure the IPs on the interface vlan.

Dan

View solution in original post

4 REPLIES 4
Highlighted
Advisor

IP on VLAN or IP on Loopback in VLAN

  Not sure what you mean by a loopback address in a given vlan.  Generally you would have a single loopback for a given L3 device and this is used by any dynamic routing protocols like ospf or eigrp as this interface is always in a up/up state . 

Highlighted
Beginner

IP on VLAN or IP on Loopback in VLAN

What I mean by that is creating a loopback interface and placing it in the particular VLAN as opposed to assigning the VLAN interface an IP address directly.  So, for example, let's take a Catalyst 6506.  If I'm hosting three VLANs 10-12 that need IP addresses (default routes for three different networks) I would potentially have three loopback interfaces with an IP address (one in each subnet consumed by those VLANs).  The alternative is to instead assign the VLAN interfaces the IP addresses and not mess with loopback interfaces.

So lets give an example.  Normally I just assign addresses to the VLANs thusly:

int vlan10

description Fiscal

ip address 10.10.10.1

int vlan11

description IT

ip address 10.10.11.1

int vlan12

description Maintenance

ip address 10.10.12.1

I'm asking if it's good, bad, or indifferent to use loopback interfaces instead:

int vlan10

description Fiscal

no ip address

int vlan11

description IT

no ip address

int vlan12

description Maintenance

no ip address

int lo10

switchport

switchport access vlan 10

switchport mode access

ip address 10.10.10.1

int lo11

switchport

switchport access vlan 11

switchport mode access

ip address 10.10.11.1

int lo12

switchport

switchport access vlan 12

switchport mode access

ip address 10.10.12.1

Highlighted

IP on VLAN or IP on Loopback in VLAN

Hi ,

You cannot configure the loopback interface as switchport. Also you cannot configure a SVI ( interface vlan ) as a switchport. So the solution is to configure the IPs on the interface vlan.

Dan

View solution in original post

Highlighted
Beginner

IP on VLAN or IP on Loopback in VLAN

Thanks!

Content for Community-Ad