ip summary-address rip Not working in Cisco packet Tracer

[Maskin_Viktor]

Hello I am trying to config router(1941 or 2811) with RIP summary address

But its showing me error in syntax

Just created new router object and typing

interface Serial0/1/0
ip add 172.16.1.1 255.255.255.0
ip summary-address rip 172.16.1.0 255.255.255.252

[Mark Malone]

whats options does it give you after ip summary-address use the ?

[Maskin_Viktor]

Only egrp

[Mark Malone · Accepted solution]

well then its not supported only eigrp is for summary addresses , does it even let you in general configure RIP in global config ..router rip  , its supported on real routers , there virtual so there stripped down images

You could do it in GNS3 as that uses full Cisco IOS images with all features available

[paul driver]

Hello 

agree with Mark it does work in gns3  simulations - just verified it

Res

paul