09-13-2008 03:18 PM - edited 03-06-2019 01:21 AM
Hi there,
I've configured two routers connected through fastethernet interface with an ipv6 address, however I can't ping each other although interfaces are up.
P1R4#sh ipv6 int brief
FastEthernet0/6 [up/up]
FE80::212:43FF:FEE3:C600
2001:410:1:2:212:43FF:FEE3:C600
P1R2#sh ipv6 int brief
ATM0 [administratively down/down]
unassigned
FastEthernet0 [up/up]
FE80::213:C3FF:FE30:8B09
2001:410:1:2:213:C3FF:FE30:8B09
P1R2#ping ipv6 2001:410:1:2:212:43FF:FEE3:C600
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:410:1:2:212:43FF:FEE3:C600, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
P1R2#
Anyone knows why I can't ping it?
Thanks
09-13-2008 04:50 PM
Did you enable IPv6 routing on those devices?
__
Edison.
09-14-2008 02:07 PM
Yes,
ipv6 unicast-routing
09-15-2008 05:22 AM
Please provide full config along with some topology description of your network.
__
Edison.
09-15-2008 12:20 AM
Hello.
Any luck when trying to ping the link local addresses (it will make you input the interface)
Also, can the router see each other with CDP?
Simon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide