ISR 4400 bridge domain configuration

[#1]

I am able to configure a bridge domain on my router.  The issue is, and it may not be an issue.  It happens when I go to an interface.

I configure the interface

int g0/0/0

bridge-domain 100

then it gives me a sub menu.  Do I need to actually add something at the sub menu or not?  When I leave config mode and do a show command on that interface I do not see the bridge-domain that I just added.

ROUTER#config t
Enter configuration commands, one per line. End with CNTL/Z.
(config)#int g0/0/2
(config-if)#brid
(config-if)#bridge-domain 100
(config-bdomain)#exit
(config)#exit
ROUTER#
*Jun 7 07:03:40.987 EDT: %SYS-5-CONFIG_I: Configured from console by admin on consolesh run int g0/0/2
Building configuration...

Current configuration : 101 bytes
!
interface GigabitEthernet0/0/2
description EXASBNGTW01-ILOM
no ip address
negotiation auto

Thanks

[Julio E. Moisa]

Hi

Hope the following link is useful:

http://www.cisco.com/c/en/us/support/docs/lan-switching/integrated-routing-bridging-irb/200650-Understanding-Bridge-Virtual-Interface.html

:-)