Hi,
I have configured my Iomega Ix4-200d NAS wth 2 x aggregated 802.3ad nics and the switch appears to be configured as I expect with an LACP port-channel. However, I am unable to ping my NAS devices IP address (192.168.2.100) from any clients on my network, I can ping this from the switch itself.
I have a linksys wireless router that acts as my router and this is running DD-WRT firmware, the router has a static route configure for the vLANs I use. The NAS device is on vLAN 3 and the static route on the router is
Destination LAN Net: 192.168.2.0
SM: 255.255.255.0
DG: 192.168.0.10 - (This is the IP address of my switch)
I have a Cisco 3750G switch running Cisco IOS Software, C3750 Software (C3750-IPBASE-M), Version 12.2(25)SEE2 and this my config.
NAS device IP config:
IP: 192.168.2.100
SM: 255.255.255.0
DG: 192.168.2.0
Switch Port Config:
> sh etherchannel summary
Flags: D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
u - unsuitable for bundling
w - waiting to be aggregated
d - default port
Number of channel-groups in use: 6
Number of aggregators: 6
Group Port-channel Protocol Ports
------+-------------+-----------+-----------------------------------------------
1 Po1(SD) -
2 Po2(SD) -
5 Po5(SD) PAgP Gi1/0/12(D)
10 Po10(SD) -
12 Po12(SD) LACP Gi1/0/11(P) Gi1/0/13(P)
20 Po20(SD) - Gi1/0/19(D)
>sh run int port-channel 12
Building configuration...
Current configuration : 149 bytes
!
interface Port-channel12
description IOMEGA NAS Gi/1/0/11_Gi1/0/13
switchport access vlan 3
switchport mode access
switchport nonegotiate
end
>sh run int gi1/0/11
Building configuration...
Current configuration : 200 bytes
!
interface GigabitEthernet1/0/11
switchport access vlan 3
switchport mode access
switchport nonegotiate
channel-group 12 mode active
spanning-tree portfast
spanning-tree bpdufilter enable
end
sh run int gi1/0/13
Building configuration...
Current configuration : 226 bytes
!
interface GigabitEthernet1/0/13
switchport access vlan 3
switchport mode access
switchport nonegotiate
channel-group 12 mode active
spanning-tree portfast
spanning-tree bpdufilter enable
end
>sh int port-channel 12
Port-channel12 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0000.0000.0000 (bia 0000.0000.0000)
Description: IOMEGA NAS Gi/1/0/11_Gi1/0/13
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Auto-duplex, Auto-speed, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
>sh int gi1/0/11
GigabitEthernet1/0/11 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 001b.0cff.060b (bia 001b.0cff.060b)
MTU 9000 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
>sh int gi1/0/13
GigabitEthernet1/0/13 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 001b.0cff.060d (bia 001b.0cff.060d)
Description: esx1 Vlan 10
MTU 9000 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Can someone please help me out.
Many Thanks
Scott
