L3 Switch(with Intervlan) connecting to Router

[ITexpert]

Hello Guys,

I configure Aruba 2930F with Intervlan routing and configure ip routing, setup static route :  

ip routing 

vlan 1 :  ip address 10.10.31.65   255.255.255.0

vlan 50: ip address 10.110.50.1 255.255.255.0

Vlan 51 : ip address 10.110.51.1 255.255.255.0

ip route 0.0.0.0 0.0.0.0 10.10.1.1 (router interface)

then on router i configure one  port with IP 10.10.1.1 255.255.255.0 , no shutdown.

Then i configure static routes on router, ip route 10.110.50.0 255.255.255.0 10.10.31.65

                                                                   ip route 10.110.51.0 255.255.255.0 10.10.31.65

I can not ping Router ip from switch and switch from router. ?

I am confuse the port that connected from switch to router should be trunk configured or access ?

[rais]

Your route on Aruba:

ip route 0.0.0.0 0.0.0.0 10.10.1.1 (router interface)

is invalid as there is no presence of 10.10.1.x network on Aruba. Aruba can't reach 10.10.1.1 so it can't use this static route.

HTH.

[ITexpert]

Hello rais,

I change my router address to 10.10.31.75 and 10.10.31.0 is the default vlan on Aruba switch, Now i can ping my router from Aruba and vice-versa.

But when on access layer switch, I connect PC, It cannot ping router ?

I already have static route-  ip route 0.0.0.0 0.0.0.0 10.10.31.75 

[rais]

Do you have a vlan1 interface on switch with address 10.10.31.x?

Thanks.