Layer-3 Switching with SG-300 52

[hamed.davodi]

Hello, I have just bought a CISCO SG-300 52 Switch and a CISCO 2811 Router. I am trying to configure SG-300 on Layer 3 mode which is done and InterVlan routing works well. However, my hosts can not communicate with router, although I can ping router's IP from inside switch console.

It seems certain commands are different with this switch model, and I couldn't yet access my router's from any of the hosts.

Can anyone explain me how to properly configure both ends, based on diagram below, so my hosts can access router and internet?

[Karsten Iwen]

1. Has your 2811 static routes for the internal networks pointing to the swiitch-IP 10.10.10.2?
2. Is your default-route on the SG300 pointing to the IP 10.10.10.1 of the 2811?

[hamed.davodi]

Thanks, it worked fine after I added static routes for each range on Router side.