11-15-2013 12:19 PM - edited 03-07-2019 04:38 PM
I am trying to setup a 3550 switch to limit download speed to 25mb and upload 10mb on each port. I am confused on what to set my rate at and burst rate. Also do I have input vs output correct on my interface? Thank you for your help in advance.
mls qos
!
policy-map 25MB
class class-default
police ? ? exceed-action drop
policy-map 10MB
class class-default
police ? ? exceed-action drop
Interface fa 0/1
switchport access vlan 10
switchport mode access
service-policy input 10MB
service-policy output 25MB
11-18-2013 01:24 PM
This is what I have come up with, will this work on a 3550 switch to limit bandwidth per port?
mls qos
!
policy-map 10meg
class class-default
police 10000000 125000 exceed-action drop
!
policy-map 25meg
class class-default
police 25000000 312500 exceed-action drop
!
policy-map 50meg
class class-default
police 50000000 625000 exceed-action drop
!
!
!
interface FastEthernet0/1
service-policy input 25meg
service-policy output 10meg
11-19-2013 05:04 PM
That solution will not work. This is the solution I used and cofirmed working on cisco 3550 switches.
mls qos
!
class-map match-any ACL_IN
match access-group 100
class-map match-any ALL_OUT
match ip dscp 0
!
policy-map 25MBOUT_DOWN
class ALL_OUT
police 25000000 512000 exceed-action drop
policy-map 50MBOUT_DOWN
class ALL_OUT
police 50000000 768000 exceed-action drop
policy-map 10MBIN_UP
class ACL_IN
police 10000000 512000 exceed-action drop
policy-map 20MBIN_UP
class ACL_IN
police 20000000 512000 exceed-action drop
!
end
!
access-list 100 permit tcp any any
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: