Discuss Catalyst brand switches with peers and experts.
Showing results for 
Search instead for 
Did you mean: 

Get 20% off switches when you combine Cisco solutions


Forum Posts

Hi all,Can anyone suggest me a fixed configuration L3 switch with  24 10/100/1000 ports and 12 SFP based ports.I roughly remember thr is some 48 model switch out of which last few ports can be used as shared SFP but unable to trace correct model.Plea...

ashah5053 by Level 1
  • 3 replies
  • 0 Helpful votes

Hello,I am currently studying my CCNA and I have my own lab equipment at home.I am practicing the below Lab which requires;- RIP v2 to be setup and confirm that all routes are present and everything can ping each other- Then setup OSPF and confirm th...

jared.j01 by Level 1
  • 2 replies
  • 0 Helpful votes

Hi,I have a problem between two switches with etherchannel configured:  Model number                    : WS-C2960S-24TS-L  System image file is "flash:/c2960s-universalk9-mz.122-58.SE2/c2960s-universalk9-mz.122-58.SE2.bin"  Gi1/0/23  ETH-CH_1_SW-EDG...

osgpcqosg by Level 1
  • 11 replies
  • 0 Helpful votes

Dear All,i need help in configuring DMVPN for hub and spokes with two tunnels and two IPSec profiles. I hve configured both tunnels with IPSec on each site i.e Main office and branch office. When i enable firest tunnel with IPSec profile it working f...

Hi,Does someone know which code we can use  to order the upgrade for C6509E from IPBase to IPServices (via CCW tool) ?Customer runs IP base and likes to add features that need additional license to support these. Therefore the Advanced IP SERVICES is...

janvandek by Level 1
  • 1 replies
  • 0 Helpful votes

Hi there,I a 2821 with 2 Gi interfaces and 4 switch ports.  Gi0/0 is WAN and Gi0/1 is LAN, network . I want the 4 switch ports to be part of the same LAN. I have putting both ports in the same bridge group but no luck. and of course i ca...

Hi Guys,I was trying to upgrade an Cisco IE3000 switch when i realised there were 2 IOSs available for version 15.15.0(2)EY15.0(2)SEWhat is the different between these 2 versions? Which should i download?Anywhere I can read to learn more about the al...

Lim Victor by Level 1
  • 10 replies
  • 0 Helpful votes

We have a few 6509's w/ WS-SUP720-3B sup engines, that will need to be replaced because of their EoX status.http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/eol_c51-697975.htmlWe'd like to replace them w/ Sup 2T's, since they're the l...

huangedmc by Level 3
  • 4 replies
  • 0 Helpful votes

Hello,I have a 3560x-24-t-s switch running c3560e-universalk9-mz.150-2.SE3.bin - This might be a silly question, but if I put the "boot system flash:c3560e-universalk9-mz.150-2.SE3.bin" command it doesn't appear on the running or startup config betwe...