I am trying to send traffic destined TO one ip address to multiple servers. I dont want to load balance as such, but rather split it out to both or all servers in a farm. I know that this sounds like multicast but neither source or destination can be configured for multicast. (if i'm talking nonsense here and anything can do this then let me know... multicast is not something I have any real world experience with).
I was thinking that if I created a VIP there must be a way to specify rather than round robin, or least weight, etc, there must be a way to say "send to all"?
It may not be entirely possible... but let's see if we can do something about it. First of all, what is the nature of the stream? Is it TCP or UDP? Is it precisely the one single stream that you want to replicate to all servers? Are the servers in one IP subnet?
Thanks. It is one stream. The exact scenario is that our traders have dealerboard phones which need to be recorded. The phone software, helpfully ( ! ) only allows you to specify one voice recorder box. We have 2 by way of some luck and the voice provider trying to keep good favour.
What we would like to do is point the phones at a VIP for example, but when it hits that, it gets sent to both voice recording boxes. I'm pretty sure the traffic is UDP.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...