We have the following port channel configuration:
Port Channel
interface Port-channel5
switchport trunk encapsulation dot1q
switchport mode trunk
end
Interface
interface GigabitEthernet1/0/5
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 5 mode on
end
interface GigabitEthernet1/0/9
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 5 mode on
end
I would like to execute the following command on my C3750 running c3750-ipservicesk9-mz.122-37.SE.bin
port-channel load-balance src-dst-mac
And the same command on the neighbor switch which is a C3560 c3560-ipservicesk9-mz.122-55.SE.bin
Port Channel
interface Port-channel5
switchport trunk encapsulation dot1q
switchport mode trunk
end
Interface
interface GigabitEthernet0/25
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 5 mode on
end
interface GigabitEthernet0/26
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 5 mode on
end
Question:
Will connectivity between the switches be interuppted as I would like to make this change on the fly in production.
Thanks