Load Balancing Using Port Channels
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-19-2025 02:49 AM
The Cisco Nexus 9000 Series NX-OS Interfaces Configuration Guide, Release 10.5(x) tells at chapter Load Balancing Using Port Channels:
"Configuring hash load balancing applies to unicast and multicast traffic on Cisco Nexus 9200, 9300-EX, and 9300-GX Series switches."
It sounds so strange that 9300-FX series is not mentioned. Can someone explain why? Does that configuration guide section apply to 9300-FX series as well?
- Labels:
-
Other Switches
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-19-2025 03:00 AM
If thereis no restrictions then it apply to all NSK SW series.
MHM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-19-2025 03:01 AM
- Check whatever the port-channel load-balance ? command lists as options
on the 9300-fx platform.
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-19-2025 11:51 PM
If I had the 9300-fx platform available I think I would have not asked
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2025 11:13 AM
- @rootswitch Since the device runs nx-os too, you will have the same options available as on the other models,
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
