Hi all
For a fault on the phone line, my provider replaced the DSLAM connected to my router and now I can not get more to connect to the internet.
I always get the following error:
LOCAL:Max noise margin for power cutoff 31
DSL(ATM0): Using ITU sync first for 5 secs, then ANSI/ITU sync alternatively for 2 secs
Modem state = 0x9
Modem state = 0x9
Modem state = 0x10
DSL(ATM0): Received response: 0x22
DSL(ATM0): Open failed: Protocol error received -- retrying
DSL(ATM0): Using subfunction 0x0
LOCAL:Max noise margin for power cutoff 31
DSL(ATM0): GPCI[0] 0x5
DSL(ATM0): GPCI[1] 0x9
DSL(ATM0): GPCI[2] 0x1
DSL(ATM0): GPCI[3] 0x0
DSL(ATM0): Sent extended command 0x3
DSL(ATM0): 1: Modem state = 0x9
DSL(ATM0): 2: Modem state = 0x9
DSL(ATM0): 3: Modem state = 0x10
DSL(ATM0): Received response: 0x22
DSL(ATM0): Open failed: Protocol error received -- retrying
I have read several forums and I can not figure out what is the problem:
Some says it could be a hardware problem
Some says that I must upgrade my software router's IOS (my version is: Cisco IOS Software, C870 Software (C870-ADVIPSERVICESK9-M), Version 12.4(15)T13)
Some says to change:
int atm0
dsl operating-mode auto
to:
int atm0
dsl operating-mode ansi-dmt
Please help me to understand the real problem.
cox