07-13-2015 03:32 PM - edited 03-08-2019 12:57 AM
Hi
I accidentally configure vty 0 15 login local without configured any username.
I know the telnet and enable password. Is there a way to avoid the login local and go back asking for telnet and enable access?
Thanks,
Sonny
07-14-2015 01:07 AM
If you have not saved the config you put in you could reload the switch it will revert back to last saved or do a password recovery if its still asking you for a username password
did you do the console as well or just vty , if only vty you could access switch over direct console and make the changes on the vty from there
11-10-2015 02:49 AM
You can perhaps try to upload a new configuration(with login credentials or without vty 0 15 login local ) using SNMP
http://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/15217-copy-configs-snmp.html
07-14-2015 03:04 AM
If you have not saved the config, change it there, I have also made this mistake once, but I have edited it in config file.
07-25-2015 07:55 AM
If you can't access it over a vty line, and if you didn't save the config simply reload the device.
Otherwise it's a trip to the switch with a console cable
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide