cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
766
Views
0
Helpful
1
Replies

mac address not showing up without specifying the interface

Nick Cutting
Level 1
Level 1

I always though that sh mac address table dynamic interface xx/xx/xx was a subset of "sh mac address table"

6590 Version 12.2(33)SXI

I have two mac addresses on downstream switches that will only show up when using

sh mac address-table dynamic interface Te4/10

*  903  0050.77a9.6e3c   dynamic  Yes          0   Te4/10

*  903  0050.77a9.5766   dynamic  Yes          0   Te4/10

when using "old faithful"

sh mac address-table | inc 6e3c

*nothing*

or

sh mac address-table dynamic | inc 6e3c

*nothing*

nothing shows up?

anyone seen this before? is this a bug?

this vlan has no layer three interfaces

1 Reply 1

Nick Cutting
Level 1
Level 1

Anyone have any ideas?

Sent from Cisco Technical Support iPad App

Review Cisco Networking for a $25 gift card