can i configure ip to mac binding with this version of 2950 switch???
2950#sh ver Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA2, RELEASE SOFTWARE (fc1) Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Sun 07-Nov-04 23:14 by antonino Image text-base: 0x80010000, data-base: 0x8055E000
ROM: Bootstrap program is C2950 boot loader
System returned to ROM by power-on System image file is "flash:/c2950-i6q4l2-mz.121-22.EA2.bin"
cisco WS-C2950T-24 (RC32300) processor (revision R0) with 21055K bytes of memory. Processor board ID FOC0916W1AB Last reset from system-reset Running Enhanced Image 24 FastEthernet/IEEE 802.3 interface(s) 2 Gigabit Ethernet/IEEE 802.3 interface(s)
32K bytes of flash-simulated non-volatile configuration memory. Base ethernet MAC Address: 00:13:C4:6F:09:C0 Motherboard assembly number: 73-6114-10 Power supply part number: 34-0965-01 Motherboard serial number: FOC091605EP Power supply serial number: DAB09093UVE Model revision number: R0 Motherboard revision number: A0 Model number: WS-C2950T-24 System serial number: FOC0916W1AB Configuration register is 0xF
are you talking about dhcp client identifier or arp to mac binding , even though switch is very old I know they can do dhcp not sure on client identifier but if you have access you can see if that option is there when you try create a pool , it should definitely do arp to mac binding
