09-04-2014 09:26 AM - edited 03-07-2019 08:38 PM
I am having hard time in configuring LLQ on a ME 6524. I am getting following error:
priority command is not supported in output direction for this interface
Configuration failed!
I am new to this platform, kindly suggest....
Below is required info and my QOS policy:
!
mls qos
!
ip access-list extended VC-IPs
permit ip host 10.110.210.144 host 10.158.227.15
exit
!
class-map match-any RTP
match protocol rtp
exit
!
class-map match-any VC
match access-group name VC-IPs
exit
!
policy-map VC-QOS
class RTP
priority 2000000
set ip dscp ef
exit
class VC
bandwidth 2000000
set ip dscp af41
exit
class class-default
fair-queue
random-detect
exit
!
int gi1/2
service-policy out VC-QOS
exit
!
end
!
priority command is not supported in output direction for this interface
Configuration failed!
DEL-6524-01#sh int gi1/2 capabilities
GigabitEthernet1/2
Model: ME-C6524GT-8S
Type: 10/100/1000BaseT
Speed: 10,100,1000,auto
Duplex: half,full
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: none
Flowcontrol: rx-(off,on,desired),tx-(off,on,desired)
Membership: static
Fast Start: yes
QOS scheduling: rx-(1q2t), tx-(1p3q8t)
QOS queueing mode: rx-(cos), tx-(cos)
CoS rewrite: yes
ToS rewrite: yes
Inline power: no
Inline power policing: no
SPAN: source/destination
UDLD yes
Link Debounce: yes
Link Debounce Time: no
Ports on ASIC: 1-12
Remote switch uplink: no
Dot1x: yes
Port-Security: yes
DEL-6524-01#sh int gi1/2
GigabitEthernet1/2 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 5475.d066.2936 (bia 5475.d066.2936)
Description: SPECTRANET 70 Mbps Link from Delhi BSZ to Mumbai CST - 10.10.100.2
Internet address is 10.10.100.2/30
MTU 1500 bytes, BW 71680 Kbit, DLY 100 usec,
reliability 255/255, txload 14/255, rxload 16/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100/1000BaseT
input flow-control is off, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 3w6d
Input queue: 0/75/3/3 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 4760000 bits/sec, 3585 packets/sec
30 second output rate 4122000 bits/sec, 3441 packets/sec
L2 Switched: ucast: 1993601 pkt, 247523714 bytes - mcast: 1 pkt, 64 bytes
L3 in Switched: ucast: 8796674958 pkt, 2056594112735 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 9305831488 pkt, 2381278643432 bytes mcast: 0 pkt, 0 bytes
8829433964 packets input, 2059985043121 bytes, 0 no buffer
Received 40007 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
9341111134 packets output, 2384759833734 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
DEL-6524-01#sh ip int gi1/2
GigabitEthernet1/2 is up, line protocol is up
Internet address is 10.10.100.2/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP Null turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Probe proxy name replies are disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: Ingress-NetFlow
Output features: IP Post Routing Processing, Post-Ingress-NetFlow, Egress-Netflow, HW Shortcut Installation
Post encapsulation features: MTU Processing, IP Protocol Output Counter, IP Sendself Check, HW Shortcut Installation
Sampled Netflow is disabled
IP Routed Flow creation is enabled in netflow table
IP Bridged Flow creation is disabled in netflow table
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
IP multicast multilayer switching is disabled
DEL-6524-01#sh version
Cisco IOS Software, s6523_rp Software (s6523_rp-ADVIPSERVICESK9-M), Version 12.2(33)SXH7, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Fri 12-Mar-10 04:46 by prod_rel_team
ROM: System Bootstrap, Version 12.2(17r)SX3, RELEASE SOFTWARE (fc1)
DEL-6524-01 uptime is 1 year, 12 weeks, 6 days, 4 hours, 5 minutes
Uptime for this control processor is 1 year, 12 weeks, 6 days, 4 hours, 7 minutes
Time since DEL-6524-01 switched to active is 1 year, 12 weeks, 6 days, 4 hours, 5 minutes
System returned to ROM by power cycle at 12:26:40 UTC Tue Oct 11 2011 (SP by power-on)
System restarted at 17:18:48 IST Thu Jun 6 2013
System image file is "sup-bootflash:s6523-advipservicesk9-mz.122-33.SXH7.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco ME-C6524GT-8S (R7000) processor (revision 1.6) with 983040K/65536K bytes of memory.
Processor board ID SAL1443XPW1
R7000 CPU at 300Mhz, Implementation 0x27, Rev 3.3, 256KB L2, 1024KB L3 Cache
Last reset from power-on
1 Virtual Ethernet interface
32 Gigabit Ethernet interfaces
1915K bytes of non-volatile configuration memory.
65536K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
09-04-2014 11:04 AM
Hey Deepak,
Regarding the error message, check the configuration guide for 12.2SX release. It looks like priority command is not supported under policy map. Check the following link:
HTH.
Regards,
RS.
09-04-2014 10:25 PM
I also tried must with Bandwidth command too, it didn't work either.
Any idea how to make bandwidth reservations in such case
09-05-2014 01:36 AM
Could you check the below link:
http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-6500-series-switches/white_paper_c11_538840.html
HTH
Regards
Inayath
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide