Hi. I hope someone can help with this. Here's a summary of my configuration
IP Address: 10.10.10.254 /24
Port 1: vlan1 access
Port 2: vlan1 access
Port 3: vlan1 access
Port 4: vlan 2 access
IP Address: 192.168.10.252 /24
Ports 1-6 access - vlan 2
Ports 7-8 trunk - native vlan1 - all vlans allowed
Port 1 of MX connects to a fibre media converter which in turn connects to port 8 of MS120 switch. Both MX and MS devices are up. However, when connecting laptop to switchports 1-6, I get no IP address and there is no Internet activity. The AP also connects to these ports and as a result is not working. If the config looks ok, could the problem be being caused by the media converter?
Currently when changing the Authentication Template there is no choice but to remove SGTs,VNs and IP Pools which will clearly disrupt services.
Hitless Authentication was introduced in Cisco DNA Center 184.108.40.206 providing...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 220.127.116.11 as the RP for these groups:18.104.22.168/3222.214.171.124/32126.96.36.199/24188.8.131.52/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...