Missing License boot and crypto ikev2 features

[henning.micah]

I have a Cisco 3825 ISR running the C3825-ADVENTERPRISEK9-M software, version 15.1(4)M10.  I'm missing the crypto ikev2 command:

router(config)#crypto ?
  call          Configure Crypto Call Admission Control
  ctcp          Configure cTCP encapsulation
  dynamic-map   Specify a dynamic crypto map template
  engine        Enter a crypto engine configurable menu
  gdoi          Configure GDOI policy
  identity      Enter a crypto identity list
  ipsec         Configure IPSEC policy
  isakmp        Configure ISAKMP policy
  key           Long term key operations
  keyring       Key ring commands
  logging       logging messages
  map           Enter a crypto map
  mib           Configure Crypto-related MIB parameters
  pki           Public Key components
  provisioning  Secure Device Provisioning
  wui           Crypto HTTP configuration interfaces
  xauth         X-Auth parameters

So I figured I'm missing a technology package or license level.  To verify, I was going to try to add an evaluation license, but it seems the license boot command is missing too:

router(config)#license ?
  accept     Accept all further License Agreements
  agent      Configure LIC_AGENT
  call-home  license call-home config commands

What is it that I'm doing wrong?  Am I using the wrong system image?  Thanks in advance.

[Karsten Iwen · Accepted solution]

You are not missing a package or image, you are missing a newer router. The ISR G1 routers (1800, 2800, 3800) don't support IKEv2. ISR G2 (1900, 2900, 3900) do support it.

[henning.micah]

Thanks Karsten.  I can't imagine why that would be the case, since the hardware could surely support it.  But alas, Cisco.  I appreciate the response!