To test further, you should create an access list and log on that. You should start seeing entries. The problem is that generating traffic doesn't get logged by default unless there's an issue to log. You can create an acl and log icmp traffic like this:
access-list 101 permit icmp host 10.10.10.10 any log
access-list 101 permi ip any any
ip access-group 101 in
Now if you ping anything from the 10.10.10.10 host, you should see some entries in the log.
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...
Cisco Champion Radio · S7|E45 Network Insights with AI Endpoint Analytics
Identifying who and what is on the network is a challenge for many organizations. Incomplete visibility makes it difficult to implement advanced security policies and recommendatio...