08-30-2012 09:49 AM - edited 03-07-2019 08:37 AM
Hello,
Is there a way or product out there that can help me
- Monitor switch port configs against a baseline?
- Show me if a list of ports has been disconnected for a period of time ?
For example, our baseline config for network port can be seen below. If a software can send us an alert email if someone else change any of that.
int g1/0/1
switchport mode access
switchport nonegotiate
spanning-tree portfast
spanning-tree guard root
switchport port-security
switchport port-security maximum 5
switchport port-security aging time 1
switchport port-security violation shutdown
spanning-tree bpduguard enable
no speed
no duplex
Thanks
08-30-2012 01:20 PM
http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dtitraps.html
And
http://www.cisco.com/en/US/docs/ios/netmgmt/command/reference/nm_20.html#wp1074055
Take a look at this and remember that you could even set in interface config a link status command.
It is your choice then if to read it in your buffered logg:
Conf t
Logg buff 16384 deb
End
Wr
!
Or to send all the traps to a syslog server and analysing them in the morning maybe after a good breakfast ...ahahhaha
Take care
Alessio
Sorry,it was a ram joke....
Sent from Cisco Technical Support iPad App
08-30-2012 01:23 PM
The link is something about ADSL !?
Not sure If you were answering other topic but copy and pasted to the wrong one
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide